Design in Verilog on the MAX10 FPGA, an electronic system that uses ADC, SERDES, Counters, Memories

Dear sir I have more than 9 years experience in digital design using Verilog, please check m profile, also please message me so that we can dicuss

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded programming and verilog codding using pic and dspic controllers for Power projects, Boot loaders, EEprom. I designed sine wave inverters for standalone and grid tie Inverters. I designed projects like Off line UPS up to 3 KVA, synchronous rectifiers, Solar MPPT chargers, Battery chargers ,Grid tie inverters design with PLL and feedback control circuit emergency light of 66W and Online UPS control cards, Battery Charging power supplies, LED drivers for PWM controlling and dimming, SMPS, Power supplies. I have experience in schematics and PCB design experience in Altium and ORCAD. I am ready to work for you. Please contact for further discussion.

Hello, My name is Mohamed. I have 5 years experience in Digital design and HDL. I checked your project description about implementing Verilog code on MAx10 FPGA for ADC, SERDES, Counters, Memories. I can handle your task in the deadline and deliver it with high quality contact em for more details. Rgeards

Hi, -FPGA design engineer since last 7 years -Expertise in verilog/VHDL Please find below details of the projects TSMAC Hardware acceleration(3months) The project is to develop hardware acceleration block for TSMAC IP to reduce the overhead created in software for packet creation and detetction. CSI-2 transmitter and receiver(6months) The project is to develop CSI-2 transmitter and receiver IPs according to the mipi standards eMMC Host Controller and Device controller(3months) The project is to develop eMMC host and Device controller IP according to the JEDEC standards. Mobile camera–testing(3months) The project is to develop 3D image processing algorithms on 1K sensor from PMD technologies High resolution camera(6.5months) The project is to develop 2D and 3D image processing algorithms on 100K sensor from Infineon sensor -Test project for DDR2 accesses -Development of calibration module -Development of chain control module -Development of control signal generator -Development of Generic LUT module -Development of Divider radix-2 algorithm -Development of atan calculator -Development of MCB reader state machine Color Pipeline(15months) The project is to develop 2D and 3D image processing algorithms on Aptina sensor -Development of Generic Frame Buffer pCore -Development of data compression and data packing pCore -Development of data packing pCore Video Processing Unit(13 months) -Improvement in algorithms to reduce FPGA resource utilization and decrease latency

Hello, I am guessing you are the employer for which I had a project a few weeks ago. I believe I can very well do this project too. Unfortunately I do not have the MAX10 FPGA board, but I hope you are able to help for some testings of the code which may be needed. The fact that I don't have the board concerns me mostly with regard to the ADC. But for the rest I believe there shouldn't be a problem. After all I have experience with programming external peripherals on the Digilent Nexys3 Spartan6 FPGA development board. I will like to discuss the project some more, to know just how easy or tough it really will be for me.

A proposal has not yet been provided

I have more than five years experience in RTL implementation using Verilog/VHDL. I have made interface with ADC before on vertix 7 board.