GWI - perspective Cabin for elevator

Hi im charbel from IETG Group our client GWI want to fix a 360 degree round glass elevator in his project we dont have concrete shaft for the lift we will build a stainless steel structure and fix the lift inside the structure the consultant want from us as elevator supplier to show him how the cabin will look like .kindly check attachment for osaka cabin, but the ceiling of the cabin he want it to have bigger glass he want a stainless steel frame of 20 cm and the glass ceiling coming inside the stainless. cabin diameter is 1600 mm so if frame will be 20 cm we will have then a round glass ceiling of 120 cm dia , and also he want to see how the steel structure where will look like kindly check attachment photos to give u more ideas this lift is hydraulic the piston is coming under the coming not on the sides we will have 2 u beam 200 x100 x 8 mm thickness on sides,one on left side, one on right to fix the guiderails those ubeam will be covered by stainless steel as client dont want it painted and coming full hight from from pit to roof we will support them only in the pit and on the roof project is 2 stop pit is 2 metre hight of ground floor is 4,5 m hight of first floor is 3.8 m doors are curved doors we need also to fix 2 tube beam in front just same hight of doors hight doors hight is 2.1 m include the upper frame glass panel is 2 m and frame upper glass panel is 10 cm so this tube beam 100x100x5 mm thickness is just 2.1 m and its just to support the installation of the doors regarding horizal beam its also tube beam 100x100 x 5 mm in the pit we have one full horizontal beam for the full dia 2400 mm in the roof also one horizontal beam for the full dia those tube beam will connect the front vertical tube beam of the doors to the vertical ubeam of the guiderails and connect the ubeam of guiderails together then we have 4 horizontal tube 100x100x5 mm half round front front vertical tube beam to middle ubeam to support the installation of the doors operator 1 under door of ground 1 upper door of ground floor 1 under door of first floor 1 upper door of forst floor please remember those 4 horizontal beam are half round connect the front tube beam which are 100x100x 5 mm to the middle u beam which are 200 x100 so just the horizontal tube beam which are on in pit and one of roof will be full round connected all the structure together finally this full structure will covered by round glass we will have one piece of glass from front front tube beam to the middle u beam coming in U channel Stainless steel frame i believe its clear how the half front part of shaft will be covered by glass now for rear half part of the shaft, which is from the left ubeam to the right u beam we will have 2 piece of glass supported in middle of rear side by spacer please remember the front tube beam 100x100x5 mm are just same height of the doors and doors with upper frame are 2.1 m and the u beam 200x100x8 mm are for the full height of the lift starting from pit to roof regards Charbel Gedeon