Arduino contacts to servo

I need to have the programming sketch done for an Arduino Uno to have two small hobby servo motors (servo A & B) go to 6 different positions from six separate contact closures. When there are no contact closures on the Arduino, servos A & B need to go to position 1. Each servo will need to be able to be "adjusted" in the code so each servo can be set at the proper locations. Position 1 through position 7. When contact 1 is closed, servos A & B need to go to position 2. If contact 1 is opened, , servos A & B return to position 1. While contact 1 is closed and if contact 2 is closed, servos A & B need to go to position 3. While contacts 1 and 2 are closed and if contact 2 is opened, servos A & B return to position 2. While contacts 1 and 2 are closed and if contact 3 is closed, servos A & B need to go to position 4. While contacts 1, 2 & 3 are closed and if contact 3 is opened, servos A & B return to position 3. While contacts 1, 2 and 3 are closed and if contact 4 is closed, servos A & B need to go to position 5. While contacts 1, 2, 3 & 4 are closed and if contact 4 is opened, servos A & B return to position 4. While contacts 1, 2, 3 and 4 are closed and if contact 5 is closed, servos A & B need to go to position 6. While contacts 1, 2, 3, 4 & 5 are closed and if contact 5 is opened, servos A & B return to position 5. While contacts 1, 2, 3, 4 and 5 are closed and if contact 6 is closed, servos A & B need to go to position 7. While contacts 1, 2, 3, 4, 5 & 6 are closed and if contact 6 is opened, servos A & B return to position 6. I have an Arduino with 2 servos and six switches connected. Once the sketch is complete and sent to me, I will test the the code/operation of the devices for porper operation.