Bearing the warehouse environment conditions

Bearing the warehouse environment conditions Warehouse at room temperature Store room temperature 6205 Bearings Of FANADE [login to view URL] warehouse should adopt the measures of the air conditioning or beside, control within 5 ~ 25 ℃. Room temperature is too low, rust-proof oil hardening and cracks, harmful material such as moisture will make it through direct contact with the bearing surface crack corrosion, room temperature is too high, rust-proof oil will melt, lose protective effect on the surface of bearing, large temperature difference between day and night or spend large temperature range, moisture in the atmosphere will be on a bearing surface condenses into water droplets, that cause bearing corrosion. If conditions do not have air conditioning, in less than 5 ℃ should be used when the far-infrared electric furnace for the indoor temperature, and unfavorable use varieties of fuels such as coal, lumber, oil heating, because it can produce harmful gases, cause bearing corrosion. Really have difficulty, also can use enclosed fireplace or a stove, with good sealing flue and high smoke, all will be the products of combustion, exhaust to the outside. The number of heating equipment and distribution should be in place to ensure that the bearing place can be evenly temperature increase for the principle. When higher than 25 ℃, had better use natural convection cooling method, avoid to use easy to dust or from moisture forced fan air cooling method, if you must use the electric fan, appropriate USES high installation position of the window fan pages, the number of the fan and the distribution of the choice principle should make indoor storage bearing temperature cooling evenly as much as possible, air flow without vortex without blind Angle. Avoid by all means to the air bearing, the portal often pay particular attention to, open the inlet due to high temperature bearing steep encounter cold air will condense water droplets, this library in the morning also should be paid attention to when changing room air. Humidity of the warehouse The warehouse where the bearing, the indoor relative humidity shall be maintained at 45% ~ 60%, exceed this limit, dehumidification measures should be taken. Best is set in the inlet side of the air shaft dehumidification devices, properly placed indoors such as silica gel hygroscopic material. High humidity, easy to cause bearing corrosion, shorten the life of "stock" of bearing inventory safety period, rainy day ban raincoat, such as wet shoes home. The indoor air condition To the warehouse where the bearing, the indoor air should be clean, clean, dry, do not contain acid gas, steam or other corrosive gas, the best temperature adjust to appropriate also. If no air filter, using at least the dustproof screen window. The indoor environment The warehouse is best kept bearing. If must deposit together with other materials when one room, common storage items is absolutely not acid, alkali, salt, or other chemicals, more do not allow contact with these items. Items must be clean and dust-free, properties of common storage stability, not gone mouldy or release harmful gases. Even the qualified goods to bearing store respectively, so as to avoid confusion. Warehouse location Into the warehouse location bearing elected in a quiet, clean environment space, not all the year round in the harmful air source or dust contamination source leeward, especially away from the chemical warehouse, heat treatment and pickling workshop, iron foundry and forging workshop, even grindery. The door of warehouse unfavorable toward the south.