Arduino Programmer who is experienced with Marlin firmware, Http Wifi, SD Card

We require an Arduino programmer who is experienced with Marlin firmware. Need to configure marlin for multiple printing heads. The G-code file will be generated by CURA software which is already compaitable with Marlin.

The objective of project is:

A smart phone app(already developed) will send GCODE file(generated by cura software) to 3D printer using Wifi(http or UDP Protocol). A dedicated microcontroller receives the file and starts printing. Printing parameters e.g. temperature, remaining time etc. needed to be broadcasted after every 5 sec and user can check the status on its app on phone.

Multiple arduino mega boards or Yun can be used for this purpose. Our current printing setup has 2 printing heads.

All of this must result in a stable running system with safety/error procedures implemented.

Only bid if you have experience,and provide us with a description of relevant project experience. When completing the above steps we will provide you with more specific project information. We will have online skype [url removed, login to view] start you also need to sign an NDA.

The budget of this project is limited but for more big projects in future, a good freelancer will receive the project request directly.

Sumup:

1. Marlin Firmware Configuration(for 2 Heads) to print a cura generated Gcode file. Online documnetation is available. Motion control hardware is standard reprap controller board.

2. Implementation of wifi http or udp to receive the Gcode file.

3. Transmission of printing parameters to mobile via wifi.

Printing 3D Arduino Ingeniería Microcontrolador Inalámbrico

Nº del proyecto: #8896262

Sobre el proyecto