Hello,
I am looking for someone that can write me a script for an Axis Camera.
For example,
1. while the below are true,
Video is Lost on any channel, and/or
Video Motion Detection Daemon Stopped and/or
temperature is outside temp range of the camera and/or
SD Card recording is disrupted and/or
Tamper is Active and/or
Fan Failed
Set Digital output to OFF (Low), otherwise set digital output to ON(High).
2. Cron Command to reboot camera every 15 days an also start the Motion Detection Daemon after the reboot.
Thank you
Hello,
I understood the initial scope of this project.
Although i want to discuss further this job in order to
prepare the final concept for this project.
After Complete discussion over the call or in chat, i
will prepare following things for you
- Technical Project Proposal
- Flow chart for this Project
- Execution plan (Step by step procedure with explanation how and at what that we are going to execute a particular task)
Based on your data, for the step 1 signal or interrupt code will be checked, for the worst case scenario. The software used for camera is mapped with the code that is newly added for your step 1. Later the rebooting will be easy task for step 2.
The data I needed is how axis camera software is working in behind code analysis and to check the daemons used by its firmware over the Linux OS.