Microcontroller Programming and Circuit / PCB Designing

Hi, I am looking for a Engine & Motor Synchronizing Controller. Please find attached Diagram for better idea.... THE MAIN CONCEPT OF APPLICATION: 1- Engine's RPM will be detected by a Non-Contact RPM detector. This RPM information will be given to the Controller. 2- Controller will run the Motor on same RPM as received/detected from of Engine. Reference Line: [login to view URL] 3- There are some other side line MINOR conditions too (i.e when to ON/OFF the motor? Motor will run on SAME RPM or little less/more, etc), which I will mention in detail once you will be shortlisted. 4- Controller board should run on 10V to 14V DC. 5- Motor Minimum Specification: Brush/Brushless 48V DC, 17 Horse Power, High Torque (up to 180nm) at Low RPM (i.e Forklift Motor, Treadmill Motor or better). I have theoretically designed this system, which I would like you to convert it in to a controller (to program micro controllers and make a fully working PCB prototype). NOTE: Once you will successfully complete the project then you will courier the controller to me (I will pay for the shipment) and also share all the source codes and electrical designs, etc with me. Please answer all following questions: 1- Have you made a project for Synchronisation of DC motors via IR/RF, in past or any related project? 2- Can you Synchronize two DC motors via RF/IR? 3- Are you good in Microcontroller programming? 4- Are you good in Circuit/PCB designing? 5- If you have fully understood the project then please explain what you have to do in 2-4 lines (in your own words)? THANKS!