Assembly and FPGA COmputer systems Engineering...MICRO PROCESSOR

hi sir I am an expert electrical engineer I can do it for you. Please share the further details of the task so that I can complete it. I assure you quality work and on time delivery. Regards

I am working as Lab Engineer at FAST National University Pakistan, in Electrical Department, I have conducted the followings Labs, and also supervised Projects related to these labs. 1. Control System Design & Modelling (Matlab & Simulink) 2. Digital Logic Design (Verilog, VHDL) 3. Digital System Design (Verilog, VHDL) 4. Computer organization & Assembly Language (8086 processor, 8051 controller) 5. Electric Machines 6. Circuit Analysis and Design etc. I assure you, if you assign your project to me, you surely gonna work with me in future.

Hi, I'm an embedded systems engineer. I have very good knowledge in what comes to micro processors, fpga and assembly. Although I would like to know more about the project. Check my feedback and portfolio for further information. Feel free to contact. Hope to hear from you.

A proposal has not yet been provided

Hello, I'm an electronic designer with 25+ years of experience. I design Hardware and Firmware You don't post any inside about your needs. Then, I will give you my skills. I hope I can help you in your project I design electronics products, begining from the scratch (client definitions) up to the production, including: Architecture definition Component Selection Schematics / PCB design Firmware and software development (C, VHDL, Assembler) Prototype production Final documentation / Test software for production Hardware: Schematic Capture (Altium Designer), including creation of new components PCB Design (Altium Designer): Multilayer 3D Modelling New Components Design BGA, Ultra Fine Pitch and normal components Blind, Buried and normal Vias Clearance: 5 mils Firmware: MicroController programming: C, Assembler FPGA: VHDL. Creation the cores with graphics tools (FPGA Advantage), independent of the Platform/Language. I can send snapshots of previous work. Please, feel free in contact me for further details.

I have an extensive experience as Engineering Technician, Designer & Draftsman in various Thai and Italian companies. I can make assemblies by SolidWorks. Check my portfolio to see some samples of my projects.

I am an experienced FPGA design engineer. i have vast experience with Cyclone FPGA's and SOC based Embedded Systems design.

i can make project in assembly , if you talk in PM and tell more about project, if i can do this i will otherwise i will tell straight forwardly.