Plastic Astronaut helmet with visor with 3D printable file in STL format

Estado: Closed
Premio: $150
Propuestas recibidas: 23
Ganador: makhan22

Winner

Resumen del concurso

I'm needing to design a plastic Astronaut helmet with a spring loaded mirrored lens visor. It will need a small contained square over the mouth for a voice box to be inserted. The measurements on the voice box to come later.

The visor will cover the entire face, and held down by a latch, and pop open/up with springs so the face fully shows when latch is undone. Attached is a good starting point.

Habilidades recomendadas

Winner

Publica un concurso similar

Comentarios del empleador

“Amazing work, creative, and enjoyable to work with. Highly recommend!”

adschiel, United States.

Principales propuestas de este concurso

makhan22 India

0
prashant8080 India

0
prashant8080 India

0
prashant8080 India

0
alders5991 Colombia

0
Cobot Estonia

0
alders5991 Colombia

0
prashant8080 India

0
prashant8080 India

0
prashant8080 India

0
prashant8080 India

0
Vadymykh Ukraine

0
prashant8080 India

0
meongwae Indonesia

0
makhan22 India

0
Vadymykh Ukraine

0

Ver más participaciones

Tablero de aclaración pública

Organizador del concurso
- 5 años atrás
Hello all, and thank you all for your entries. A winner has been decided and has been notified. Thank you again.
- 5 años atrás
amirfreelancer12
- 5 años atrás
HI , working on it , almost finish , please wait
- 5 años atrás
ahmadnazree
- 5 años atrás
Hi CH, please rate #22 . Thank you very much.
- 5 años atrás
prashant8080
- 5 años atrás
If I provide you the update, is there any chances you will respond ? or can guide with a corrections ?
( As I have prepared the Entire Model by using your picture as a reference, I feel that there is something still remaining, and that is what I am expecting from you if you can send me the feedback for the same ? )
- 5 años atrás
1. Organizador del concurso
  - 5 años atrás
  Yes, I will give feedback for every entry. Thank you for your interest.
  - 5 años atrás
Organizador del concurso
- 5 años atrás
Thanks for the interest. Size will be for an average size adult head... Not overly snug like a baseball helmet, but loose easy to get on and off... I would like to receive JPG photos displaying the helmet from all sides, and a 3D printable file in STL format.
- 5 años atrás
Vadymykh
- 5 años atrás
Any information about 1) size 2) dimensions 3) end result? What do you expect to receive? .STL, .STP, .JPG?
- 5 años atrás